================================================================================
                                样例使用说明
================================================================================
功能描述：
此样例演示了LPTIM单次模式事件唤醒STOP模式。

Function descriptions:
This example demonstrates the LPTIM single mode event wake-up STOP mode.
================================================================================
测试环境：
测试用板：PY32M010_STK
MDK版本： 5.28

Test environment:
Test board: PY32M010_STK
MDK Version: 5.28
================================================================================
使用步骤：
1. 编译下载程序到MCU，并运行；
2. 按下按键进入stop模式；
3. 200ms后唤醒stop模式并循环进入stop模式再唤醒；
4. LPTIM中断中LED以2.5hz闪烁，while中PA3以2.5hz翻转；

Example execution steps:
1. Compile and download the program to MCU and run it;
2. Press the button to enter stop mode;
3. Wake up the stop mode after 200ms and cycle into the stop mode before waking up;
4. In the LPTIM interrupt, the LED flashes at 2.5Hz, while in the while function,
PA3 flips at 2.5Hz;
================================================================================
注意事项：
如果需要使用按键:
StartKit版本为V1.0,需将StartKit.h中的StartKitVersion 2 注释掉，并打开
StartKitVersion 1
StartKit版本为V1.0以上版本,则无需操作

Notes:
If you need to use buttons:
StartKit version is V1.0, please comment out StartKitVersion 2 in StartKit.h and 
open StartKitVersion 1
If the StartKit version is above V1.0, no operation is required
================================================================================